Citect SCADA supports two different software licensing models:
Follow these steps to locate the exact center of a wall stud: How To Use a Stanley Stud Finder
: Open the rear compartment and connect a fresh 9-volt alkaline battery. stanley fatmax stud finder 400 manual verified
Operating the Stanley FatMax Stud Finder requires calibrating the unit against a flat, stud-free surface while holding the activation button until a ready signal appears. For accurate detection, move the sensor slowly across the wall and mark both edges of the stud to locate the center. For the full, verified instructions, refer to the Stanley Tools Support Portal How To Use a Stanley Stud Finder Follow these steps to locate the exact center
When the center or edge is detected (usually signaled by a continuous beep or a solid "CENTER" light), mark the spot using the built-in notch or marking hole. www.stanleytools.ca Magnetic vs. Electronic Models Magnetic Stud Finder - STANLEY® Tools For the full, verified instructions, refer to the
Sounds distinct tones when it successfully calibrates and when it reaches the center of a stud. Operating Instructions (Verified Manual Steps) 1. Preparation and Battery Installation Open the battery compartment on the back of the unit.
Connect a (Type 6LR61) to the clip and secure it.
FLEXERA Softkey Licensing
The FLEXERA softkey solution stores license information on a FlexNet Enterprise License Server. The Citect SCADA client process will retrieve licenses from this server as required by the Citect SCADA system. To activate and administer licenses, you use the Floating License Manager (see Activate Licenses Using the Floating License Manager).
In both cases, Citect SCADA uses a Dynamic Point Count to determine if your system is operating within the limitations of your license agreement. This process tallies the number of I/O device addresses being used by the runtime system.
A point limit is allocated to each type of license included in your license agreement. These license types include:
A special OPC Server License is also available if you want to run a computer as a dedicated OPC server. For more information, contact Technical Support.
If required, you can specify how many points will be required by a particular computer (see Specify the Required Point Count for a Computer).
Note:
• There is no distinction between a Control Client and an Internet Control Client.
• There is no distinction between a View-Only Client and an Internet View-Only Client.
See Also
Published June 2018