| Last visit was: Fri May 08, 2026 10:38 pm | It is currently Fri May 08, 2026 10:38 pm |
If your AP runs lightweight firmware and you have no controller:
To move from Lightweight mode (WLC-based) to Autonomous mode, or to simply upgrade your existing Autonomous AP, follow these steps via the Command Line Interface (CLI): Ap3g1-k9w7-tar.153-3.jf15.tar Download -
: Ensure you have a TFTP server like Tftpd64 running on your computer and that UDP port 69 is open in your firewall. Compatibility & Limitations Hardware : This specific image is for hardware. Installing it on AP3G2 hardware (like the or 3700 series) will result in a boot failure. If your AP runs lightweight firmware and you
Understanding the Cisco AP Firmware: ap3g1-k9w7-tar.153-3.jf15.tar Understanding the Cisco AP Firmware: ap3g1-k9w7-tar
Network administrators typically seek this file to repurpose older enterprise hardware for home or lab use without the need for a dedicated controller. Converting to Autonomous mode allows the device to act as a traditional standalone router or access point. Installation and Recovery
For further documentation on software types and platform compatibility, refer to the Cisco Community Knowledge Base .
FAQ